MA9071 elektrolytlösning för syremätare, gjord för Milwaukee's polarografiska probe/sensor. En högkvalitativ elektrolytlösning är nödvändigt för att behålla livslängden på din syremätares probe. Perfekt till t.ex Milwaukee MW600 Syremätare.

Milwaukee MA9071 Elektrolytlösning för syremätare
Volym: 230ml

DESIGN FEATURES
PRECISE FORMULATION
Factory mixed using reagent grade chemicals in a dedicated, temperature controlled environment.

TRACEABLE
Product labeled with product code, lot number and expiration date.

SECURE
Air tight bottle with tamper-proof seal.

USE AND CARE
“OPEN AIR” CALIBRATION PROCEDURE FOR THE MW600 DISSOLVED OXYGEN METER

1. Remove the membrane
Take the membrane off the end of the probe and dry the diode off.

2. Zero out the display
Connect the probe to the base unit and turn the unit on. Your display should read 0.0. If it does not, go to the position “0” screw on the front of the unit with the screw driver provided and through the access hole make the unit display read 0.0.

3. Fill the membrane
Go to the membrane and put the “O” ring inside the membrane on the shoulder at the base of the threads. Fill the membrane to just short of the “O” ring with MA9071 electrolyte solution. Be sure that there are no bubbles inside the membrane. (Air bubbles are the main cause of calibration failure)

4. Attach the membrane
Screw the membrane on to the probe.

5. Let stablize
Turn the meter on and hang the probe off the end of a table pointing down and let the unit display stabilize (this may take 5 to 15 minutes)

6. Adjust
Push down and hold the “Cal” button on the front face of the meter and with the screwdriver go to the front Cal position “100%” and make the display read 100.

You are now calibrated.